Testing equipment for wire and cable
High-frequency Spark tester for wire and cable production line with CE certificate:
SS015K series high-frequency spark tester is an efficient and reliable product inspection device that can be used to precisely detect the broken skin, pinhole and bare copper of the conductor of the various wire and cable. It can detect the defective layer without damaging the inside electrical conductor. By using high frequency (3KHZ) and high volte electrode to replace traditional (50/60HZ) high volt electrode, its electrode tip can select a 50mm beaded-contact, copper brush, carbon brush or a roller, which can shorten installation dimension greatly and enhance detection speed to be ranging from 1000m/min to 2400m/min. This device developed based on Taiwan, Europe and American technology combination is very reliable and smart.
Specifications:
Test Voltage:1.0~15.0KV. Cable Diameter: 0~25mm. Output Frequency: 2.5-3.5KHz normal. Fast recovery time after fault (0.1s)
The Sine Wave Spark Tester is a fast and reliable instrument used in distinguish wire faults and detecting bare wires. Its high-speed fault detection feature gives you prompt information without worsening the condition of the wire after the test.
The use of high frequency (3KHz) enables a traditional commercial power frequency bead chain electrode to be shortened to 120mm HS015E Model.
The Sine Wave Spark Tester is quality-assured to meet your needs.
Basic Function:
1.Fast recovery time after fault (0.1 second).
2.Occupies short space in line and with improvement factor of 50 compared to
3.traditional CT power frequency electrode.
4.Voltage Display: 0.0~15.0KV digit, 14.2mm LED display, Accuracy +/- 1% of reading
5.Output Control: Front Panel Reset in Manual Mode. Closure time is selectable
6.0.2s/2s/5s in main board by jumper JP, Form C relay contacts (250VAC/5A) for all
7.wire faults detected.
8.Limits the fault current without damaging the test equipment.
9.Short exposure time to corona does not degrade nor damage good insulation.
10.Distinguishes all wire faults and detects bare wire.
11.Safety Switch interlock.
Basic Specification:
| Specification | ZL-1007 |
| Output Voltage | 0.0~15.0KV R.M.S. |
| Test Voltage | 1.0~15.0KV R.M.S. |
| Cable Diameter | 0~25mm |
| Maximum Load Current | 4mA Resistive,40mA Capacitive |
| Output Frequency | 2.5-3.5KHznormal |
| Electrode lengths | Bead Chain 120mm |
| Fault Indication | Indicating lamp,Counting by Digital Counter |
| Output Control | 1 Form C relay Contacts(220VAC/5A)for all wire faults and bare wire faults detected |
| Input Control | SP1, SP2 input interlock control |
| Operating Model | Extruder Continuous Application |
| Power Source | 175~264 Volts, 180VA, Single phase, 50/60 Hz |
| Operation Temperature | +4~45°C |
| Operation Humidity | <90%RH |
| Signal Cable Lengths | 5M |
| Weight | Control Unit =5 kgs, Electrode = 8.5 kgs |
| Dimension Controller | 360(L)x485(W)x90(H) mm |
| Gauge Head | 330(L)x200(W)x390(H) |
| Line Speed | 2000 M/min. maximum* |
